VectorSave™ 40 M300

Drone rescue Systems

VectorSave™ 40 M300

VectorSave™ 40 is now available for the DJI M300. It’s suited for M300 with a maximum takeoff weight of 8kg. If your MTOW is over this you should use the VectorSave™ 50 for M300

VectorSave™40 M300 is total solution for DJI Matrice 300 series. VectorSave™40 is based on patented ultra light launcher that uses loaded spring to deploy parachute. Since it is mechanical spring it does not have transportation limits like other systems using compressed gas or pyrotechnic explosives.

Automatic deploy

VectorSave™40 M300 incorporates automated SaveSense™ sensors and firmware to detect if props have stopped and free fall or over 70 degree tilt has occurred after propulsion is lost. It operates by its own independent power.

VectorSave™ drone rescue system for DJI Matrice 300 @8kg MTOW

Complete solution against power failure

Extra security may be needed if flight is operated over populated area. We were asked to develop rescue solution for this range of drones that are widely used by law enforcement or fire departments to mention few target groups. In typical use the flight take place in urban environment where it is imperative to minimize risk of possible failure that may cause drone to fall from sky. VectorSave™40 M300 system connects with Paramount™ clip. Paramount™ allows easy removal and clip on without tools. Paramount™ base clip connects to M300 rear arms and is easily removed.

VectorSave™ 40 M300 @8kg

Paramount™ Clip-on solution | Fully automatic | Ultra light

Parachute size 4,0 sqm

System weight 434 g

Paramount 59 g

Harness rope tensile strength 430 kg

Technology spring

Trigger SaveSense™